Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 148

Hard disk drive (HDD) / solid state drive (SSD)
▶ Release all HDD modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD module" on page
CAUTION
The HDD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD dummy module" on page
Removing the defective 3.5-inch HDD backplane
▶ Disconnect all cables from the HDD backplane.
▶ If applicable, disconnect the ODD power and SATA cable to make room to
remove the HDD backplane easier.
Figure 66: Removing the 3.5-inch HDD backplane
▶ Pull the HDD backplane upward until the three hooks disengage (see
circles).
▶ Take out the HDD backplane.
Installing the new 3.5-inch HDD backplane
A
Figure 67: Installing the 3.5-inch HDD backplane
148
A A
Upgrade and Maintenance Manual
144.
141.
RX1330 M4