Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 298

System board and components
Figure 208: Installing the TPM
▶ Connect the TPM to the system board (1).
▶ Fasten the TPM with the special screw for the TPM using the TPM bit insert
or TPM module fixing tool (Japan) (2).
CAUTION
▶
Do not fasten the screw too firmly.
▶
Stop it by extent where the head of the screw lightly touches the
TPM. Torque: 0.6 Nm (not used in Japan).
Concluding steps
▶ Install the riser module 3, see
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Resuming BitLocker functionality" on page
▶ Enable the TPM in the system board BIOS, see
system board BIOS" on page
Enabling the TPM in the system board BIOS
Proceed as follows:
▶ Switch on or restart your server.
298
"Installing a riser module" on page
64.
52.
56.
58.
298.
Upgrade and Maintenance Manual
86.
"Enabling the TPM in the
61.
RX1330 M4