System board and components
Replacing the microSD card
▶ Remove the Dual microSD 64GB Enterprise, see
microSD 64GB Enterprise" on page
▶ Remove the defective microSD card from the Dual microSD 64GB
Enterprise.
Proceed as described in the following:
▶ To eject the defective microSD card, gently push it in and then let go, see
Figure
224.
▶ Pull the microSD card straight out of its slot.
CAUTION
(not valid for Europe, Middle East, India and Africa)
The microSD card contains customer information.
▶
After removing the microSD card, hand the card over to the
customer.
▶
If the customer requests disposal of the defective microSD
card, proceed as follows: Using a pair of side-cutting pliers,
cut the microSD card in half.
▶ Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
▶ With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see
▶ Install the Dual microSD 64GB Enterprise, see
64GB Enterprise" on page
Concluding steps
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
324
320.
318.
64.
52.
56.
58.
Upgrade and Maintenance Manual
"Removing the Dual
Figure
225).
"Installing the Dual microSD
RX1330 M4