Replacing An Fjbu - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

Power supply unit (PSU)
Removing an FJBU
Figure 48: Removing an FJBU
▶ Press in on the green locking latch (1).
▶ While keeping the green locking latch pressed, pull the FJBU out of its bay
(2).
CAUTION
▶
Never leave the bay for the FJBU empty.
▶
Install a new FJBU or install the dummy cover.
Installing the dummy cover
▶ Install the dummy cover, see
Concluding steps
No steps needed.
6.5.3

Replacing an FJBU

Customer Replaceable
Unit (CRU)
Tools: tool-less
Note for servers using CMA (Cable Management Arm)
Regarding of removing the FJBU, additional tasks are needed, due to an
interference between CMA stopper and the FJBU.
126
"Installing the dummy cover" on page
Upgrade and Maintenance Manual
Hardware: 5 minutes
112.
RX1330 M4