Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 111

▶ Remove the PSU and install the dummy cover carefully.
Note for PSU1:
Remove the PSU1 carefully while lifting PSU1 and bringing PSU1 to
the right, in order to avoid interference.
▶ Mount the complete assembly (CMA stopper, the crossbar and the CMA)
again into the rail.
Preliminary steps
▶ Only when replacing a PSU in a non-redundant configuration:
down the server" on page
▶ Remove the power cord from the PSU, see
on page 46.
Removing a hot-plug PSU
Figure 36: Removing the PSU
▶ Push the handle of the PSU halfway upward in the direction of the arrow (1).
▶ Press in on the green locking latch (2).
RX1330 M4
45.
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Disconnecting the power cord"
"Shutting
111