Job Recall - Canon Color imageCLASS MF9220Cdn Basic Operation Manual

Job Recall

You can recall the last three addresses, scan settings, and send settings which have been set
in the <Log>, and then send your documents.
– The settings such as destinations, scan settings and send settings are stored in a log. The actions below after you change
settings are not recorded in a log:
• Pressing the (Start) or
• Activation of the Auto Clear mode.
• Turning OFF the machine.
– Identical send settings are stored only once in recall memory.
– If <Restrict New Addresses> in <Restrict the Send Function> in <System Management Set.> under <Additional Func.> is
set to <On>, the addresses specified from the Address Book are only recalled.
– The settings that were stored in memory are not erased even when the main power is turned OFF.
– If <Restrict Sending From Log> in <Restrict the Send Function> in <System Management Set.> under <Additional Func.>
is set to <On>, you cannot specify a destination using the <Log>. (See "Security, " in the e-Manual.)
1
Place your originals.
2
Press (Main Menu).
3
Use [▼], [▲] or
<Send/Fax>, then press [OK].
(Reset) or (Main Menu).
(Scroll Wheel) to select
4
Use [▼], [▲] or
<Log>, then press [OK].
5
Use [▼], [▲] or
<Mode 1>, <Mode 2> or <Mode 3>, then
press [OK].
You can check the recall settings by pressing the
left Any key to select <Details>.
Job Recall
(Scroll Wheel) to select
(Scroll Wheel) to select
5-73