Table of Contents
Advertisement
heat sink and system board spare part kits. The following illustration shows the replacement thermal
material locations.
Thermal paste is used on the heat sink (1) and system board component (2) as shown in the following
illustration.
To install the heat sink, reverse this procedure.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 5-10
Power connector cable description and part number
Description
Power connector cable
Power connector bracket (in Bracket Kit)
Before removing the power connector cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Disconnect the cable from the system board (1).
2.
Remove the Phillips M2.0 × 4.0 screw (2) that secures the power connector cable to the computer.
Preparation for disassembly on page
Bottom cover on page
28).
28).
Battery on page
29).
Power connector cable
Spare part number
N02674-001
N07102-001
39
Advertisement
Table of Contents
