Power Connector Cable - HP 250R G9 Maintenance And Service Manual

To reassemble and replace the display assembly, reverse this procedure.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-15 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the USB board (see
5. Remove the display assembly (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the cable from the retention clips and routing channel (2) built into the fan and speaker.
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
USB board on page
Display assembly on page
31).
41).
50).
Spare part number
L51995-001
31).
Power connector cable 57