Table of Contents
Advertisement
d.
If you need to remove the display cable, peel the tape off the connector on the back of the panel (1),
disconnect the cable from the panel (2), and then remove the cable from the left hinge and clips in
the display rear cover (3). The display cable is available as spare part number N07110-001.
e.
When installing a display panel, use the following illustration to determine proper display panel
adhesive installation locations along the entire length of both hinge brackets.
NOTE:
Replacement display panels come with the bracket installed. To install the panel, screw the
bracket onto the display back cover, install pull tape onto bracket, and then align the panel on the
top of the display back cover with the bracket.
After installation, if the panel is misaligned or you can see tape from the assembled display near
the bezel, you must disassemble and reassemble the panel to correct.
8.
If you need to remove the hinges from the display rear cover:
a.
Remove the four Phillips M2.5 × 2.5 screws (1) from each hinge.
b.
Remove the display hinges from the display rear cover (2).
The display hinges are available in the Hinge Kit as spare part number N00687-001.
Display assembly
47
Advertisement
Table of Contents
