3.
Lift the back of the board up, and then pull it into the computer to remove it (4).
To install the USB/audio board, reverse this procedure.
Speaker
To remove the speaker, use this procedure and illustration.
Table 5-7
Speaker description and part number
Description
Speaker
Before removing the speaker, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the speaker:
1.
Disconnect the speaker cable from the system board (1).
2.
Remove display cable from the clip on the left side of the speaker (2).
3.
Remove the four Phillips M2.0 × 6.0 screws from the speaker (3).
Preparation for disassembly on page
Bottom cover on page
28).
28).
Battery on page
29).
Spare part number
N07104-001
Speaker
35