Table of Contents
Advertisement
4.
If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
To install the WLAN module, reverse this procedure.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-4
Solid-state drive descriptions and part numbers
Description
256 GB, PCIe
128 GB, PCIe
Solid-state drive cover (in Bracket Kit)
Before removing the solid-state drive, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1.
Remove the Phillips M2.0 × 2.5 screw (1) that secures the drive to the computer.
32
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
28).
28).
Battery on page
29).
Spare part number
M11042-002
M11040-002
N07102-001
Advertisement
Table of Contents
