Table of Contents
Advertisement
12.
If you need to remove the display and camera cable, disconnect the cable from the camera module (1),
and then release the cable from the display rear cover (2).
The display and camera cable is available as the following spare part numbers:
M50425-001: HD, touch screen
M50426-001: HD, nontouch
M50427-001: FHD, nontouch
13.
If you need to remove the WLAN antenna cables, remove the cables from the clips on the left (1) and
right (2) sides of the display rear cover, and then peel the antennas off the inside of the display rear
cover (3). The wireless antennas and cables are available as spare part number M50375-001 for models
with dual antennas and M50374-001 for models with a single antenna.
For a list of display rear cover spare part numbers, see
Reverse this procedure to reassemble and replace the display assembly.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Display assembly subcomponents on page
Component replacement procedures
18.
53
Advertisement
Table of Contents
