Table of Contents
Advertisement
Disconnect the cable from the ZIF connector on the camera module (1), and then carefully release
▲
the module from the display (2). (The module is attached with double-sided adhesive.) The camera
module is available as spare part number N07105-001.
7.
If you need to remove the display panel:
NOTE:
The display panel comes with the hinge brackets installed. The brackets are secured to the panel
using adhesive pull tape.
a.
Remove the four Phillips M2.5 × 2.5 screws (1) from each hinge.
b.
The display panel is secured to the display rear cover with tape that is installed under the panel.
First, remove the tape of the left and right sides of the panel, and then lift the bottom of the panel
up to access and remove more tape.
To remove the panel, use tweezers to grasp the end of the tape on the left and right sides of the
panel (1). While turning the tweezers, wrap the tape around the tweezers (2) as you continue to
pull the tape out from behind the display panel. You must pull the tape multiple times before it is
completely removed.
Display assembly
45
Advertisement
Table of Contents
