Table of Contents
Advertisement
3.
Remove the power button board (3) and cable.
Reverse this procedure to install the power button board.
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the keyboard/top cover (see
5.
Disconnect the battery cable from the system board (see
6.
Remove the WLAN module (see
7.
Remove the system board (see
8.
Remove the display assembly (see
Remove the power connector cable:
1.
Slide the power connector cable (1) out of the cavity in the base enclosure.
44
Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
WLAN module on page
27).
System board on page
29).
Display assembly on page
Spare part number
809824-001
21).
Battery on page
23).
36).
Advertisement
Table of Contents
