Power Connector Cable - HP ZHAN 66 Pro 13 G2 Maintenance And Service Manual

Power connector cable

Table 6-10 Spare part description and number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in "Battery Safe mode"
3. Remove the bottom cover
4. Remove the battery
5. On models with a WLAN module, disconnect the antenna cables from the WLAN module
Bluetooth combo card on page
6. On models with a WWAN module, disconnect the antenna cables from the WWAN module
module on page
Remove the power connector cable:
1. Remove the two Torx T8 2.5×4.0 screws from the right hinge (1).
2. Rotate the hinge up from atop the power connector (2).
3. Disconnect the cable from the system board (3).
4. Use a tool to lever the connector up and out of the computer (4).
Reverse this procedure to install the power connector cable.
66 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Preparation for disassembly on page
(Bottom cover on page
(Battery on page 32).
35).
37).
(Battery Safe mode on page
31).
Spare part number
L01048-001
30).
30).
(WLAN/
(WWAN