Table of Contents
Advertisement
Figure 90. PCIe riser-card assembly installation
Step 3.
Reconnect all the cables disconnected previously.
After installing the PCIe riser-card assembly, complete the following steps:
1. Reinstall the top cover (see
2. Reconnect the power cords and any cables that you removed.
3. Install the server in the rack.
4. Power on the server and any peripheral devices.
Remove an adapter
Use this procedure to remove an adapter.
Follow the following instructions accordingly to the location where the adapter has been installed.
Remove an adapter from the system board
Before removing an adapter from the system board:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
4. Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
5. Remove the top cover (see
To remove an adapter from the system board, complete the following steps:
Step 1.
Disconnect any cables (including external ones) from the adapter.
Step 2.
Open the retention latch.
"Install the top cover" on page
49).
11).
.
"Remove the top cover" on page
134).
"Safety" on page iii
https://www.youtube.com/playlist?list=
133).
.
Chapter 3
Hardware replacement procedures
and
"Installation
91
Advertisement
Table of Contents
