Table of Contents
Advertisement
TCM/TPM adapter replacement
Use this procedure to remove or install the TCM/TPM adapter.
Remove the TCM/TPM adapter (for Chinese Mainland only)
Use this information to remove the TCM/TPM adapter.
"Read the
installation
Guidelines" on
page 49
Before removing the TCM/TPM adapter:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
4. Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
5. Remove the top cover (see
6. Disconnect the USB 3.0 cable of operator panel tray assembly, and remove it vertically from the system
board.
Figure 123. Removing USB 3.0 connector vertically
To remove the TCM/TPM adapter, complete the following steps:
Step 1.
Locate the TCM/TPM connector on the system board (see
25).
for this task"
49).
11).
.
"Remove the top cover" on page
"Power off
the server
on page 11
"Safety" on page iii
https://www.youtube.com/playlist?list=
133).
"System-board connectors" on page
Chapter 3
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 51
and
"Installation
.
Hardware replacement procedures
129
Advertisement
Table of Contents
