Table of Contents
Advertisement
A video of this procedure is available at YouTube:
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
5. Remove the top cover (see
To remove the operator panel tray assembly, complete the following steps:
Step 1.
Remove the fan cage assembly (see
Step 2.
Disconnect USB cables and front operator panel cable from the system board.
Figure 76. USB 2.0 cable and front operator panel cable
Table 38. USB 2.0 cable and front operator panel cable
USB 2.0 cable
1
Note: Make sure the USB 3.0 connector stays vertical when being removed from the system
board.
Figure 77. Removing USB 3.0 connector vertically
Step 3.
Remove the USB 3.0 cable from the cable guide.
Step 4.
Remove the screw that secures the tray assembly.
Step 5.
Grasp the tab on the rear of the tray assembly, and push it out from the server.
.
"Remove the top cover" on page
"Remove the fan cage assembly" on page
https://www.youtube.com/playlist?list=
133).
Front operator panel cable
2
.
Chapter 3
Hardware replacement procedures
59).
83
Advertisement
Table of Contents
