Table of Contents
Advertisement
Step 1.
Open the bracket on the PCIe riser-card assembly.
Step 2.
Align the adapter with the connector on the PCIe riser-card assembly.
Step 3.
Push the adapter into the PCIe riser-card assembly until it clicks into place.
Figure 94. Adapter installation to the PCIe riser-card assembly
Step 4.
Close the bracket.
After installing an adapter in a PCIe riser-card assembly, complete the following steps:
1. If the adapter is installed to a PCIe riser-card assembly, install the PCIe riser-card assembly to the server
(see
"Install the PCIe riser-card assembly" on page
2. Reinstall the top cover (see
3. Reconnect the power cords and any cables that you removed.
4. Install the server in the rack.
5. Power on the server and any peripheral devices.
Power supply unit replacement
Use this procedure to install or remove power supply units.
Remove a hot-swap power supply unit
Use this procedure to remove a hot-swap power supply unit.
S002
CAUTION:
ThinkSystem SR850P Maintenance Manual
94
"Install the top cover" on page
89).
134).
Advertisement
Table of Contents
