Table of Contents
Advertisement
Before installing the TCM/TPM adapter:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3. Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
4. Disconnect the USB 3.0 cable of operator panel tray assembly, and remove it vertically from the system
board.
Figure 125. Removing USB 3.0 connector vertically
To install the TCM/TPM adapter, complete the following steps:
Step 1.
Locate the TCM/TPM connector on the system board (see
25).
49).
.
"Safety" on page iii
https://www.youtube.com/playlist?list=
"System-board connectors" on page
.
Chapter 3
Hardware replacement procedures
and
"Installation
131
Advertisement
Table of Contents
