Table of Contents
Advertisement
4. Remove the top cover (see
5. Disconnect the USB 3.0 cable of operator panel tray assembly, and remove it vertically from the system
board.
Figure 62. Removing USB 3.0 connector vertically
6. Remove PCIe riser-card if necessary (see
7. Remove LOM adapter if necessary (see
To remove the M.2 backplane, complete the following steps:
Step 1.
Remove the M.2 backplane from the system board by pulling up on both ends of the backplane at
the same time.
Note: Pull the M.2 backplane straight up when removing it from the system board.
Figure 63. M.2 backplane removal
To remove an M.2 drive from the M.2 backplane, see
page
75.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
"Remove the top cover" on page
"Remove the PCIe riser-card assembly" on page
"Remove the LOM adapter" on page
"Remove an M.2 drive from the M.2 backplane" on
133).
69).
.
Chapter 3
Hardware replacement procedures
87).
73
Advertisement
Table of Contents
