Table of Contents
Advertisement
Figure 79. Operator panel tray assembly installation
Step 2.
Install the tray assembly to the server with a screw.
Step 3.
Connect the front operator panel cable and USB cables to the system board.
Figure 80. USB 2.0 cable and front operator panel cable
Table 39. USB 2.0 cable and front operator panel cable
USB 2.0 cable
1
Note: Make sure the USB 3.0 connector stays vertical when being pushed into the connector on
the system board.
Front operator panel cable
2
.
Chapter 3
Hardware replacement procedures
85
Advertisement
Table of Contents
