Table of Contents
Advertisement
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
4. Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
5. Remove the top cover (see
To remove the front VGA assembly, complete the following steps:
Step 1.
Remove the fan cage assembly (see
Step 2.
Disconnect the VGA cable from the system board.
Figure 49. Location of the front VGA connector on the system board
Step 3.
Remove the four screws that fix the front VGA assembly.
49).
11).
.
"Remove the top cover" on page
"Remove the fan cage assembly" on page
"Safety" on page iii
https://www.youtube.com/playlist?list=
133).
.
Chapter 3
Hardware replacement procedures
and
"Installation
59).
65
Advertisement
Table of Contents
