Table of Contents
Advertisement
Notes: If the Physical Presence Policy has been disabled:
1. Set the hardware Physical Presence jumper on the system board to assert Physical Presence.
2. Enable the Physical Presence Policy using either F1 (UEFI Settings) or Lenovo XClarity Essentials
OneCLI.
Assert Physical Presence through the Lenovo XClarity Controller
Complete the following steps to assert Physical Presence through the Lenovo XClarity Controller:
1. Log in to the Lenovo XClarity Controller interface.
For information about logging in to the Lenovo XClarity Controller, see the "Opening and Using the
XClarity Controller Web Interface" section in the XCC documentation version compatible with your
server at
https://sysmgt.lenovofiles.com/help/topic/lxcc_frontend/lxcc_overview.html
2. Click BMC Configuration ➙ Security and verify that Physical Presence is set to assert.
Assert Physical Presence through the hardware
You can also assert hardware Physical Presence through the use of a jumper on the system board. For more
information about asserting hardware Physical Presence through the use of a jumper, see
jumpers, and buttons" on page
Set the TPM version
To be able to set the TPM version, Physical Presence must be asserted.
The Lenovo XClarity Provisioning Manager or the Lenovo XClarity Essentials OneCLI can be used to set the
TPM version.
To set the TPM version:
1. Download and install Lenovo XClarity Essentials OneCLI.
a. Go to
http://datacentersupport.lenovo.com
b. Click Drivers & Software.
c. Navigate to the version of Lenovo XClarity Essentials OneCLI for your operating system and
download the package.
2. Run the following command to set the TPM version:
Note: You can change the TPM version from 1.2 to 2.0 and back again. However, you can toggle
between versions a maximum of 128 times.
To set the TPM version to version 2.0:
to TPM2.0 compliant"
-–bmc userid:password@ip_address
To set the TPM version to version 1.2:
to TPM1.2 compliant"
-–bmc userid:password@ip_address
where:
• <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o)
• <ip_address> is the IP address of the BMC.
For more information about the Lenovo XClarity Essentials OneCLI
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html
26.
and navigate to the support page for your server.
OneCli.exe config set TrustedComputingGroup.DeviceOperation "Update
OneCli.exe config set TrustedComputingGroup.DeviceOperation "Update
.
command, see:
set
.
Chapter 3
Hardware replacement procedures
"Switches,
127
Advertisement
Table of Contents
