Table of Contents
Advertisement
Remote Surveillance
12
12.1 Mobile Client Surveillance
1
Enable NAT in the NVR. Refer to
2
Scan the QRCode through the Speco Blue App available for iOS and Android to easily and securely view your
cameras.
3
Run the mobile client, go to the "Add Device" interface and then click
StartSettingsSystemInformationBasic to view the QRCode of the NVR).
4
After scanning the QRCode successfully, enter the login password to log in mobile client.
12.2 Web LAN Access
1
Click StartSettingsNetworkTCP/IP to go to the "TCP/IP" interface. Set the IP address, subnet mask, gateway,
preferred DNS and alternate DNS of the NVR.
2
Open the web browser on your computer, enter the IP address of the NVR in the address bar and then press enter
to go to the login interface as shown below. You can change the display language on the top right corner of the login
interface. Enter the username and password of the NVR in the interface and then click "Login" to go to the live view
interface.
1 1 .1. 8 NAT Configuration
Notes: 1. Please make sure that the IP address of the NVR and the computer are both in the same local
network segment. For example, supposing that the IP address of the computer is 192.168.1.41,
the IP address of the NVR shall be set to 192.168.1.XXX.
2. If the HTTP port of the NVR is not 80, but other number instead, you need to input the IP
address plus port number in the IE address bar when accessing the NVR over network. For
example, the HTTP port is 81. You should enter http://192.168.1.42:81 in the IE address bar.
Remote Surveillance
for details.
to scan the QRCode of the NVR (Go to
90
NVR User Manual
Advertisement
Table of Contents
