Motion Alarm; Motion Configuration; Motion Alarm Handling Configuration - Speco N64NR24TB User Manual

Alarm Management
alarm is triggered. To set the duration time of the video, please see
Pop-up Message Box : if enabled, the system will pop up the corresponding alarm message box automatically when
the sensor alarm is triggered. To set the duration time of the message box, please see
E-mail: if enabled, the system will send an e-mail when the sensor alarm is triggered. Before you enable the email,
please configure the recipient's e-mail address first (see

9.2 Motion Alarm

Motion Alarm : when the motion object appears in the specified area, it will trigger the alarm. You should enable the
motion of each camera first and then set the alarm handling of the camera to complete the whole configuration of the
motion alarm.

9.2.1 Motion Configuration

1 Click StartSettingsCameraMotion to go to the following interface.
2 Select the camera, enable the motion and set the sensitivity and duration of the camera.
Sensitivity : the higher the value is, the more sensitive it is to motion. You should adjust the value according to the
practical conditions since the sensitivity is influenced by color and time (day or night).
Duration : it refers to the interval time between the adjacent motion detections. For instance, if the duration time is
set to 10 seconds, once the system detects a motion, it will go to alarm and would not detect any other motion
(specific to camera) in 10 seconds. If there is another motion detected during this period, it will be considered as
continuous movement; otherwise it will be considered as a single motion.
3 Drag the camera image to set the motion area. Click "All" to set the whole camera image as the motion area. Click
"Reverse" to swap the motion area and the non-motion area. Click "Clear" to clear all the motion areas.
4 Click "Apply" to save the settings. Click "Processing Mode" to go to the alarm handling configuration interface of
the motion alarm.

9.2.2 Motion Alarm Handling Configuration

1 Click StartSettingsAlarmMotion Alarm to go to the following interface.
9. 6 .3 Display
1 1 .1.5 E-mail Configuration
59
NVR User Manual
for details.
9. 6 .3 Display for details.
for details).