Push Message; Alarm Server; Manual Alarm; View Alarm Status - Speco N64NR24TB User Manual

Alarm Management

9.6.5 Push Message

Click StartSettingsAlarmEvent NotificationPush Message to go to the interface as shown below. Check
"Enable" and then click "Apply" button to save the settings. If Push Server is online, it will push messages to the
mobile clients.

9.6.6 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server. Then select protocol. If "Send
Heartbeat" is enabled, set the interval times. After that, test the effectiveness of the alarm server. Having tested
successfully, please click "Apply". When an alarm occurs, the device will transfer the alarm event to the alarm server.
If an alarm server is not needed, there is no need to configure this section.

9.7 Manual Alarm

Click on the tool bar at the bottom of the live view interface to pop up a window. Click "Trigger" to start alarm.
Click "Clear" to stop alarm.

9.8 View Alarm Status

Click StartSettingsAlarmAlarm Status or click
the alarm status.
on the tool bar at the bottom of the live view interfaceto view
71
NVR User Manual