Device Management; Network Configuration; Tcp/Ip Configuration - Speco N64NR24TB User Manual

Nr (64 channel nvr)
Hide thumbs Also See for N64NR24TB:
Table of Contents

Advertisement

Device Management

11

11.1 Network Configuration

11.1.1 TCP/IP Configuration

Click StartSettingsNetworkTCP/IP to go to the following interface.
If the NVR has two network ports or above, you can select the network work pattern as required.
TOE: It is a technology for improving the network transmission speed. Please enable it according to the actual
network situation. If TOE is enabled, it shall be high speed mode. Then multiple address setting or network fault
tolerance can be chosen and configured. If TOE is not enabled, it shall be compatible mode. Then the network fault
tolerance cannot be selected and set up.
Network Fault Tolerance:
The two network ports will be bound to one IP address if you select the "Network Fault Tolerance" pattern. There are
many advantages of this work pattern: 1. increase the bandwidth; 2. form a network redundant array to share the
load. When a failure happens to one network port, the other port will take over the entire load immediately. The
takeover process is seamless and the network service will not be broken off.
If "Network Fault Tolerance" is selected, check "Obtain an IPv4 address automatically", "Obtain an IPv6 address
automatically" and "Obtain DNS automatically" to get the network addresses automatically, or manually enter the
network addresses. You can modify the MTU value according to the network condition (MTU, Maximum Transmission
Unit, can be modified according to network condition for higher network transmission efficiency). Click "Apply" to save
the settings.
Multiple Address Setting:
If "Multiple Address Setting" is selected, the IP addresses of the two Ethernet ports should be set respectively. Refer to
the picture as shown below.
Check "Obtain an IPv4 address automatically", "Obtain an IPv6 address automatically" and "Obtain DNS
automatically" to get the network addresses automatically, or manually enter the network addresses; select one
Ethernet port as the default route and then click "Apply" to save the settings.
Device Management
79
NVR User Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

N64nr

Table of Contents