Table of Contents
Advertisement
EZ Setup & Main Interface
Click "Next" to continue or click "Cancel" to exit the wizard.
2
Network Settings . Select the network work pattern as required. Check "Obtain an IP address automatically" and
"Obtain DNS automatically" to get the IP address and DNS automatically (the DHCP function of the router in the same
LAN should also be enabled), or manually enter them. Enter the HTTP port, RTSP port and Server port (please see
1 2 .1.2 Port Configuration
Other Network Settings.
3
UPnP settings: Check "Enable" in the interface and enter the port of external and then click "Test". If the UPnP
status were "Invalid UPnP", the port number may be wrong. Click
turns to "Valid UPnP". Refer to the following picture. You can view the external IP address of the NVR. Enter the
external IP address plus port in the address bar of your browser to access the NVR. (Please see
Configuration
for details).
DDNS Settings: Check "Enable" and then select the DDNS type. Enter the server address, domain name,
username and password according to the selected DDNS type. And then click "Register" or "Test" to test the
effectiveness of the domain name. If it is effective, you can enter the domain name in the address bar of your
browser to access the NVR. (Please see
Note: Make sure the router supports UPnP function and the UPnP is enabled in the router. S et the NVR's IP address,
subnet mask and gateway and so on corresponding to the router.
for details). Click "Next" to continue.
1 2 .1.4 DDNS Configuration
to modify the port until the UPnP status
for details).
11
NVR User Manual
1 2 .1.6 UPnP
Advertisement
Table of Contents
