Pppoe Configuration; Ddns Configuration - Speco N64NR24TB User Manual

Device Management
the video of channel 1.
② Enable RTSP and open the VLC player. After that enter the address (for example:
rtsp://192.168.1.88:554/chID=1&streamType=sub) in the network address bar of the VLC player. Then a login box will
pop up. Enter the username and password which shall be as the same as the username and password of API server.
Then you can view the video of channel 1.
Note: only some versions may support API server function. Please skip the following instructions if your DVR doesn't
support it.
API Server: You can log in the media player which supports the RTSP protocol by the username and password here.
Moreover, the third-party can further develop through API service.
Encryption type: Base64 and MD5 are optional.
Username: admin (it cannot be modified)
Password: Set it as needed.
Tips: The username and password of API Server here cannot be used to log in NVR. It is recommended to set the
password of the API server different from the password of "admin" that is used to log in NVR.

11.1.3 PPPoE Configuration

Click StartSettingsNetworkPPPoE to go to the interface as shown below. Check "Enable" in "PPPoE Settings" and
then enter the username and password obtained from the dealer. Click "Apply" to save the settings.

11.1.4 DDNS Configuration

The DDNS is used to control the dynamic IP address through domain name.Speco Technologies provides free DDNS
service with US-based servers. You can access the NVR easily if the DDNS is enabled and configured. Click
StartSettingsNetworkDDNS to go to the interface as shown below. The default DDNS type will be
"specoddns.net". The default domain name will be shown, you can use this for your domain name or enter your own.
If invalid or taken, please select another domain name. Click on test to check if ok. If so, you may now go to [your
domain name].specoddns.net with Internet Explorer and access your recorder remotely.
82
NVR User Manual