Table of Contents
Advertisement
Camera Management
automatically in the camera list. Refer to the picture below. The IP camera which occupies the PoE resource has a
prefix shown before its camera name. The prefix consists of PoE plus PoE port number. The IP camera which connects
to the PoE port cannot be deleted from the camera list manually.
The IP camera directly connected to the PoE port of the NVR through private protocol will be shown automatically
in the camera list.
One of the two conditions must be met if the IP camera which is directly connected to the PoE port of the NVR
through ONVIF protocol should be shown automatically in the camera list.
The IP camera which is directly connected to the PoE port is in the same network segment with the internal
Ethernet port.
The DHCP (obtain an IP address automatically) of the IP camera which is directly connected to the PoE port is
enabled.
If the IP camera which is connected to the PoE port cannot be displayed automatically in the camera list, please refer
to Q6 in
Appendix A FAQ
4.2 Add/Edit Camera Group
4.2.1 Add Camera Group
Click "Edit Camera Group" in the above interface to go to the interface as shown below.
Click
to pop up the window as shown below. Set the group name and dwell time (the dwell time of the camera
group sequence view) in the window. Check the cameras and then click "Add" to add group. Click
cameras in the group after adding group.
4.2.2 Edit Camera Group
for details.
21
NVR User Manual
to view the
Advertisement
Table of Contents
