Setting Up
Installing the Duplex Reversal Unit
A
Holding the Duplex Reversal
Unit in a level position with both
hands, insert the hooks into the
groove of the stand. At this point,
adjust the tip of the hooks to the
2
line on the stand (A A A A ) and insert
slowly (B B B B ). Do not let go of the
Duplex Reversal Unit even after
insertion.
The hooks of the Duplex Reversal
Unit grasp the ba r inside the
groove of the stand.
B
Supporting the Duplex Reversal
Unit, remove the stopper of the
mounting bracket on the printer.
This stopper will be used in a later
E
step
, so be careful not to lose it.
44
C
Supporting the Duplex Reversal
Unit, remove the adhesive tape
and hold the auxiliary bar in front
of the hook on the left side, and
then stand it up.
D
Hook the hole of the auxiliary bar
on the mounting bracket of the
printer.
ZDJP045J
E
In step
the position shown with a perfo-
rated line in the illustration.
ZDJP046J
, move the auxiliary bar to
ZDJP047J
ZDJP048J