Table of Contents
Advertisement
H
Tighten two screws to fasten the
1394 Interface Unit using provid-
ed screwdriver.
I
Insert the Controller Board into
the top and bottom rails, and slide
it in slowly until it stops.
Insert the Controller Board firmly
by pushing the left area as shown
in the illustration.
J
Tighten two screws to fasten the
Controller Board back into its
original position using provided
screwdriver.
ZDJP123E
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
Note
❒ After finishing all installation
for printing, you can check
whether the 1394 Interface Unit
is installed properly. Print the
Configuration Page from the
"List/Test Print" menu. If it is
ZDJP030J
installed properly, you will see
"Installed" for "IEEE1394".
❒ If the 1394 Interface Unit is not
installed properly, "Not In-
stalled" is shown. In such a case,
reinstall from step
not install it properly even after
reinstallation, contact your sales
or service representative.
Reference
See P.68 "Test Printing".
ZDJP802J
Installing Options
ZDJP803J
A
. If you can-
33
2
Advertisement
Table of Contents
