Table of Contents
Advertisement
Setting Up
B
Turn off the power switch and
unplug the power cable.
C
Remove two screws that are fas-
tening the Controller Board on
the back of the printer using pro-
vided screwdriver.
2
Reference
See P.20 "How to Use the Screw-
driver".
The removed screws will be used
later to fasten the C ontroller
Board.
D
Holding the handle, pull out the
Controller Board slowly.
E
Put the Controller Board in a flat
place.
38
F
Install the Printer Hard Disk to
the Controller Board.
G
Tighten two screws to fasten the
Printer Hard Disk to the Control-
ler Board using provided screw-
driver.
ZDJP025J
H
Connect the power cable and flat
cable to the Printer Hard Disk.
ZDJP025J
ZDJP036J
ZDJP118J
ZDJP035J
Advertisement
Table of Contents
