Table of Contents
Advertisement
F
Hold the Fuser Oil Unit in the
manner shown in the illustration.
Match (U U U U ) on the front of the Fus-
er Oil Unit and (T T T T ) on the Fusing
Unit at three places. While push-
ing the green lever on the left side
of the Fusing Unit (A A A A ), insert the
left and right protrusions of the
Fuser Oil Unit into the white
holders of the Fusing Unit (B B B B ),
and then move the Fuser Oil Unit
in the direction shown by the ar-
row (C C C C ) to attach the Fuser Oil
Unit to the Fusing Unit.
Important
❒ Be careful not to get oil on the
metal part of the left side of the
Fuser Oil Unit.
G
Holding the green handle with
one hand, use your other hand to
push the front area of the handle
to a slight slant, and then push the
Fusing Unit slowly to the back.
Confirm that the Fusing Unit is set
to the printer vertically.
Note
❒ Confirm that the Fuser Oil Unit
is facing the inside of the print-
er.
Important
❒ Confirm that the Fusing Unit is
in appropriate position.
H
Close the upper left cover (A A A A ) and
push the handle (B B B B ) slowly to the
back until it clicks.
I
Attach the External Tray to the
ZDJH054E
printer. Insert the hooks of the Ex-
ternal Tray into the printer slits,
and then lower it toward you.
ZDJH050E
Installing the Fuser Oil Unit
ZDJH051J
ZDJH010J
2
15
Advertisement
Table of Contents
