Setting Up
F
Install the User Account Enhance
Unit to the Controller Board. If
there is a screw coming out from
the place of attachment, insert the
screw in the hole at the tip of the
User Account Enhance Unit (A A A A )
and push the unit in the direction
of the arrow (B B B B ).
2
Confirm that the User Account En-
hance Unit is connected firmly to
the Controller Board.
G
Tighten the screw to fasten the
User Account Enhance Unit using
provided screwdriver.
36
H
Adjust the Controller Board to the
top and bottom rails, and then
push in slowly until it stops.
Insert the Controller Board firmly
by pushing the left area as shown
in the illustration.
ZDJP703J
I
Tighten two screws to fasten the
Controller Board back into its
original position using provided
screwdriver.
ZDJP704E
ZDJP030J
ZDJP801J
ZDJP031J