Table of Contents
Advertisement
Setting Up
C
Remove two screws that are fas-
tening the Controller Board on
the back of the printer using pro-
vided screwdriver.
Reference
See P.20 "How to Use the Screw-
driver".
2
The removed screws will be used
later to fasten the C ontroller
Board.
D
Holding the handle, pull out the
Controller Board slowly.
E
Put the Controller Board in a flat
place.
32
F
Remove the small cover plate us-
ing p rovided s crew driver as
shown in the illustration.
Note
❒ You will not use the removed
screws.
G
ZDJP025J
Install the 1394 Interface Unit on
the Controller Board. Insert the
tip of the 1394 Interface Unit into
the attachment area (A A A A ), and push
it in the direction of the arrow
(B B B B ).
ZDJP025J
Confirm that the 1394 Interface
Unit is connected firmly to the
Controller Board.
ZDJP122E
ZDJP120J
Advertisement
Table of Contents
