Table of Contents
Advertisement
C Close the upper left cover.
Note
❒ You will not use the removed
two covers.
F
Remove the protective cover on
the left side of the printer. Hold
the protective cover by both sides,
and while pushing the left side of
the cover (A A A A ), open it in the direc-
tion of the arrow (B B B B ), and then re-
move (C C C C ).
Note
❒ You will not use the removed
protective cover.
G
Attach the paper guide to the
stand. Hold the paper guide so
that its right side bends down as
shown in the illustration, and
while holding it lightly (A A A A ), in-
sert it into the holes of the stand
(B B B B ).
H
Insert the claws of the stand into
the holes on the left side of the
printer (A A A A ), and push down (B B B B ).
I
Tighten four long screws to fasten
the Duplex Reversal Unit Stand
using provided screwdriver. Fas-
ten in the order of A A A A ⇒ ⇒ ⇒ ⇒ B B B B ⇒ ⇒ ⇒ ⇒ C C C C ⇒ ⇒ ⇒ ⇒ D D D D
as shown in the illustration.
ZDJP041J
Reference
See P.20 "How to Use the Screw-
driver".
This completes the installation of
the stand. Next, install the Duplex
Reversal Unit.
ZDJP042J
Installing Options
2
ZDJP043J
ZDJP044J
43
Advertisement
Table of Contents
