Netware Printing - Gestetner DSm725e Network Manual

Appendix

NetWare Printing

Form feed
You should not configure form feed on NetWare. Form feed is controlled by the
printer driver on Windows. If NetWare form feed is configured, the printer
might not work properly. If you want to change form feed settings, always con-
figure them using Windows.
• Under Windows 95/98/Me, clear the [Form feed] check box on the [Printer Set-
tings] tab in the printer properties dialog box.
• Under Windows 2000/XP and Windows Server 2003, clear the [Form feed]
check box on the [NetWare Settings] tab in the printer properties dialog box.
4
• Under Windows NT 4.0, clear the [Form feed] check box on the [NetWare Set-
tings] tab in the printer properties dialog box.
Banner page
You should not configure a banner page on NetWare. If you want to change the
banner page setting, always configure it using Windows.
• Under Windows 95/98/Me, clear the [Enable banner] check box on the [Printer
Settings] tab in the printer properties dialog box.
• Under Windows 2000/XP and Windows Server 2003, clear the [Enable banner]
check box on the [NetWare Settings] tab in the printer properties dialog box.
• Under Windows NT 4.0, clear the [Enable banner] check box on the [NetWare
Settings] tab in the printer properties dialog box.
Printing after resetting the machine
After resetting the remote printer, the connection from the print server will be
cut off for about 30-40 seconds before re-connecting. Depending on the NetWare
specification, print jobs may be accepted, but they will not be printed during this
interval.
When using the machine as a remote printer, wait about two minutes after reset-
ting before attempting to print.
118