Gestetner DSm725e Network Manual page 81

msh> set ssl
msh> set nrs
msh> set rfu
msh> set ipp
msh> set http
msh> set rendezvous
msh> set nbt
msh> set ssdp
❖ Configuration
• Enter "up"to enable protocol, and enter "down" to disable protocol.
You can set the protocol to "active" or "inactive".
msh> set tcpip {up | down}
• If you disable TCP/IP, you cannot use remote access after logging off. If
you did this by mistake, you can use the control panel to enable remote ac-
cess via TCP/IP.
• Disabling TCP/IP also disables ftp, rsh, diprint, web, snmp, ssl, ipp, http,
rendezvous.
msh> set appletalk {up | down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set ftp {up | down}
msh> set rsh {up | down}
msh> set diprint {up | down}
msh> set web {up | down}
msh> set snmp {up | down}
msh> set nrs {up | down}
msh> set rfu {up | down}
msh> set ipp {up | down}
msh> set http {up | down}
msh> set rendezvous {up | down}
msh> set ssdp {up | down}
msh> set nbt {up | down}
Remote Maintenance by telnet
2
73