Wiconfig - Gestetner DSm725e Network Manual

Monitoring and Configuring the Printer

wiconfig

Use the "wiconfig" command to make settings for IEEE 802.11b.
❖ View settings
msh> wiconfig
2
❖ View IEEE 802.11b settings
msh> wiconfig cardinfo
• If IEEE 802.11b is not working correctly, its information is not displayed.
❖ Configuration
msh> wiconfig "parameter"
Parameter
mode [ap|adhoc|802.11adhoc]
ssid "ID value"
channel frequency "channel no."
enc [on|off]
82
Value configured
You can set the infrastructure mode(ap) , the
802.11 Ad hoc mode (802.11adhoc), or the ad
hoc mode (adhoc).
The default is ad hoc mode.
You can make settings for the SSID in the in-
frastructure mode.
Usable characters are ASCII 0x20-0x7e (32
bytes).
An SSID value is set automatically to the
nearest access point if no setting is made.
If no setting is made for the 802.11 ad hoc
mode, the same value for the infrastructure
mode or an ASSID value is automatically set.
The default is blank.
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key. The default is "11".
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.