Table of Contents
Advertisement
Section 5 Functions and Operations
5.5 Setting Prescale Values
One Point
0
ps. ax
L
(PS.AX)
0
ps. ay
L
(PS.AY)
0
ps. bx
L
(PS.BX)
0
ps. by
L
(PS.BY)
0
dp
L
(DP)
5-28
Set scaling to convert and display input values as any values.
Separate settings are made for inputs A and B.
When bank selection has been enabled, the prescale values for each
bank must be set in the prescale level. When bank selection has been
disabled, the prescale values must be set in the initial setting level.
Refer to "5.30 Using Prescale/Comparative Set Value Banks" (P.5-75).
Setting Parameter for Input A
Parameter
Input A
Prescale value X
(mantissa)
ps. ax
Input A
Prescale value Y
(exponent)
ps. ay
Input B
Prescale value X
(mantissa)
ps. bx
Input B
Prescale value Y
(exponent)
ps. by
Note: Not displayed on the K3HB-C or the K3HB-P.
The decimal point position for scaling values depends on the decimal
point position [dp] setting.
Parameter
Decimal point position
dp
Initial setting level
Set value
Meaning of set value
= 0 . 0000 to
Input A prescale value
9. 9999
mantissa
-9 to 9
Input A prescale value
exponent
= 0 . 0000 to
Input B prescale value
9. 9999
mantissa
See note.
-9 to 9
Input B prescale value
exponent
See note.
Set value
Meaning of set value
,,,,,
No decimal point
,,,,.,
One digit below the decimal
point is displayed.
,,,.,,
Two digits below the decimal
point are displayed.
,,.,,,
Three digits below the
decimal point are displayed.
,.,,,,
Four digits below the decimal
point are displayed.
R
P C
Advertisement
Table of Contents
