Setting The Function For The K3Hb-C - Omron K3HB-P User Manual

5.3 Setting the Function for the K3HB-C

■ F1: Individual Inputs
The count in incremented on input A pulses and decremented on input
B pulses.
The count is incremented on the rising edge of input A and
decremented on the rising edge of input B. When both inputs A and B
turn ON at the same time, the count does not change.
The measurement value can be obtained using the following formula:
D = C × α
C: Count
α: Prescale value A or prescale value B
D: Measurement value
Note: If F1 (individual inputs) is used, both preset value A and preset
value B must be set.
Input A
Input B
HOLD
1
Count
0
• Holding the Measurement Value
Turning ON the HOLD input temporarily stops the cumulative count
and holds the measurement value. The outputs are also held.
• Resetting the Display Value
The display value can be zeroed by turning ON the RESET input or
press the MAX/MIN Key for 1 second or longer.
While the RESET input is ON, measurement is not performed, the
display shows "-----", and all outputs are OFF.
• Compensation Value Input
Use the compensation input to start measurement from the desired
value. The compensation value must be set in advance.
5.3 Setting the Function for the K3HB-C
Initial setting level
3
2 2
1 1
3
2
5-23