Changing Normal Display Values To Maximum And Minimum Values - Omron K3HB-P User Manual

5.24 Changing Normal Display Values to Maximum
and Minimum Values
2
disp
L
(DISP)
0
L
Displays "L 0."
sv. dsp
2
L
off
Displays "L 2."
disp
2
L
pv
disp
2
L
pv
disp
2
L
max
ret
2
L
10
123. 4
123. 4

5.24 Changing Normal Display Values to Maximum and Minimum Values

The PV display value displayed after power is turned ON, after a
RESET input, immediately after moving to the RUN level, and
immediately after automatic display return to the RUN or adjustment
levels can be set to any of the following: present value, maximum
value, or minimum value.
The display value selection is set using the following parameter.
Parameter
Display value selection
disp
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least 3 s in RUN level to move to
L
the initial setting level.
3 s min.
0" is displayed on the level/bank display to indicate the initial
• "
L
setting level.
B Press the L [LEVEL] Key several times to move to the display
L
adjustment level.
2" is displayed on the level/bank display to indicate the display
• "
L
adjustment level.
C Press the M [MODE] Key to change the PV display to "disp."
M
D Press the S [SHIFT] Key to make the SV display flash.
S
• The setting can be changed when the SV display starts to
flash.
E Use the U [UP] Key to change the set value.
U
F Press the M [MODE] Key to switch to the next parameter.
M
• The set value is registered.
G Press the L [LEVEL] Key for at least 1 s to return to RUN level.
L
1 s min.
"5.25 Displaying/Not Displaying Comparative Set Values" → P.5-68
Remarks
"5.27 Using the Position Meter" → P.5-71
"5.28 Automatic Return to Normal Display" → P.5-73
Display adjustment level
Set value Meaning of set value
pv
Present value
max
Max. value
min
Min. value
R P C
5-67