Heater Settings; 0-10V Heater - Airstream EXPERT 2V2SA User Manual

EXPERT 2V2SA
10.4.

Heater Settings

1. From the main menu, select: HEATERS.
2. Use the navigation keys to select these
parameters:
Heater 1
StartT° 73.0°F
StopT° 75.0°F
(...) Idem for Heater 2
(These parameters are accessible if at least one
heating stage is enabled in the User Setup Menu.)
3. Set the following parameters:
(The parameter adjustment process is explained
in section 3.2 on page 8).
Start T° — Set the temperature below which
each heating stage starts. If you are using
heating timers, set this temperature sepa-
rately for both timer of each heating stage.
Stop T° — Set the temperature over which
each heating stage stops. If you are using
heating timers, set this temperature sepa-
rately for both timer of each heating stage.
Note that the stop temperature for a given
stage musts be at least 0.3°F higher than
its start temperature.
Time On & Off — If the heating timers are
enabled, set the Time On and Off of both
timers for each heating stage.
or
Heat 1 Timer 1
StartT° 73.0°F
StopT° 75.0°F
On: 1:00min
Off: 1:00min
Heat 1 Timer 2
StartT° 71.0°F
StopT° 73.0°F
On: 1:00min
Off: 1:00min
(...) Idem for Heater 2
10.5.

0-10V Heater

The controller has one 0-10V output that
can either be used to control heaters, fans or
actuators. This section explains how a 0-10V
heater works.
Intensity (%)
Max
Min
Off
Max T°
The 0-10V heater start at its minimum inten-
sity when the temperature falls below its start
temperature. It then increases in intensity as
the temperature decreases and reaches its
maximum intensity when the temperature gets
lower than the Max. Temperature value.
EXPERT 2V2SA, rev. 10
0-10V Heater
T° of
Min T° Stop T°
0-10V
heater
probes
35