Airstream EXPERT 2V2SA User Manual page 19

EXPERT 2V2SA
Curve Settings
1. From the main menu, select: SET POINT
/ CURVE.
2. Use the navigation keys to select this
screen:
1. day 1
Setp 82.0°F
(This screen is accessible if the set point curve
is enabled in the User Setup Menu).
3. Set the following parameters:
(The parameter adjustment process is explained
in section 3.2 on page 8).
1. day 1
Setp 82.0°F
2. day 5
Setp 78.0°F
...
10. day 40
Setp 62.0°F
Curve status
Off
These parameters can only be modi-
fied while the curve is off.
Day numbers — Set the day at which each
curve step starts.
Setp — Assign a temperature set point to
each step of the curve.
Curve status — Select "Yes" to enable
the curve (or "No" to disable it). Once the
curve is on, the controller automatically
adjusts the set point between consecutive
points of the curve; for this reason, curve
steps cannot be modified while the curve
is running.
If all curves are disabled (Min.Vent,
Set Point & 0-10V Heat curves), the
controller will automatically set the day
number back to 1 day when a curve
is being activated.
EXPERT 2V2SA, rev. 10
19