Using The Ftp Command From The Command Line; Figure 158 Telnet In Menu 24.5 - ZyXEL Communications Wireless Router P-334 User Manual

Figure 158 Telnet in Menu 24.5

Menu 24.5 - System Maintenance - Backup Configuration
To transfer the configuration file to your workstation, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current Prestige configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Prestige manual.
Press ENTER to Exit:

30.2.2 Using the FTP Command from the Command Line

1 Launch the FTP client on your computer.
2 Enter "open", followed by a space and the IP address of your Prestige.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "bin" to set transfer mode to binary.
6 Use "get" to transfer files from the Prestige to the computer, for example, "get rom-0
config.rom" transfers the configuration file on the Prestige to your computer and renames
it "config.rom". See earlier in this chapter for more information on filename conventions.
7 Enter "quit" to exit the ftp prompt.
Chapter 30 Firmware and Configuration File Maintenance
Prestige 334 User's Guide
288