Ftp Session Example Of Firmware File Upload; Tftp File Upload; Figure 164 Ftp Session Example Of Firmware File Upload - ZyXEL Communications Wireless Router P-334 User Manual

Prestige 334 User's Guide
4 Enter your password as requested (the default is "1234").
5 Enter "bin" to set transfer mode to binary.
6 Use "put" to transfer files from the computer to the Prestige, for example, "put
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the Prestige
and renames it "ras". Similarly, "put config.rom rom-0" transfers the configuration file
on your computer (config.rom) to the Prestige and renames it "rom-0". Likewise "get
rom-0 config.rom" transfers the configuration file on the Prestige to your computer and
renames it "config.rom." See earlier in this chapter for more information on filename
conventions.
7 Enter "quit" to exit the ftp prompt.

30.4.4 FTP Session Example of Firmware File Upload

Figure 164 FTP Session Example of Firmware File Upload

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
More commands (found in GUI-based FTP clients) are listed earlier in this chapter.

30.4.5 TFTP File Upload

The Prestige also supports the uploading of firmware files using TFTP (Trivial File Transfer
Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware
and the configuration file, follow the procedure shown next.
1 Use telnet from your computer to connect to the Prestige and log in. Because TFTP does
not have any security checks, the Prestige records the IP address of the telnet client and
accepts TFTP requests only from this address.
2 Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System
Maintenance.
295
Note:
The Prestige automatically restarts after a successful file
.
upload
Chapter 30 Firmware and Configuration File Maintenance