Pppoe Encapsulation; Outgoing Authentication Protocol; Figure 103 Menu 11.1 Remote Node Profile For Pppoe Encapsulation - ZyXEL Communications Wireless Router P-334 User Manual

Table 74 Menu 11.1 Remote Node Profile for Ethernet Encapsulation
FIELD
Edit IP
Session Options
Edit Filter Sets
Edit Traffic
Redirect
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

23.2.2 PPPoE Encapsulation

The Prestige supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use
PPPoE encapsulation when you're using the Prestige with a DSL modem as the WAN device.
If you change the Encapsulation to PPPoE, then you will see the next screen. Please see the
appendix for more information on PPPoE.

Figure 103 Menu 11.1 Remote Node Profile for PPPoE Encapsulation

Rem Node Name= MyISP
Active= Yes
Encapsulation= PPPoE
Service Type= Standard
Service Name=
Outgoing:
My Login=
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP

23.2.2.1 Outgoing Authentication Protocol

Generally speaking, you should employ the strongest authentication protocol possible, for
obvious reasons. However, some vendor's implementation includes a specific authentication
protocol in the user profile. It will disconnect if the negotiated protocol is different from that in
the user profile, even when the negotiated protocol is stronger than specified. If you encounter
a case where the peer disconnects right after a successful authentication, please make sure that
you specify the correct authentication protocol when connecting to such an implementation.
Chapter 23 Remote Node Configuration
DESCRIPTION
This field leads to a "hidden" menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.3 - Remote Node Network Layer Options.
This field leads to another "hidden" menu. Use [SPACE BAR] to select Yes and
press [ENTER] to open menu 11.5 to edit the filter sets. See the Remote Node
Filter section for more details.
Press [SPACE BAR] to select Yes or No.
Select Yes and press [ENTER] to configure Menu 11.6 Traffic Redirect Setup.
Select No (default) if you do not want to configure this feature.
Menu 11.1 - Remote Node Profile
Press ENTER to Confirm or ESC to Cancel:
Prestige 334 User's Guide
Route= IP
Edit IP= No
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedules=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Edit Traffic Redirect= No
226