Prestige 334 User's Guide
Table 49 Peer ID Type and Content Fields
PEER ID TYPE CONTENT
E-mail
The domain name or e-mail address that you use in the Content field is used for identification purposes
only and does not need to be a real domain name or e-mail address. The domain name also does not
have to match the remote router's IP address or what you configure in the Secure Gateway Address
field below.
15.8.1 ID Type and Content Examples
Two IPSec routers must have matching ID type and content configuration in order to set up a
VPN tunnel.
The two Prestiges in this example can complete negotiation and establish a VPN tunnel
Table 50 Matching ID Type and Content Configuration Example
PRESTIGE A
Local ID type: E-mail
Local ID content: tom@yourcompany.com
Peer ID type: IP
Peer ID content: 1.1.1.2
The two Prestiges in this example cannot complete their negotiation because Prestige B's
Local ID type is IP, but Prestige A's Peer ID type is set to E-mail. An "ID mismatched"
message displays in the IPSEC LOG.
Figure 63 Mismatching ID Type and Content Configuration Example
PRESTIGE A
Local ID type: IP
Local ID content: 1.1.1.10
Peer ID type: E-mail
Peer ID content: aa@yahoo.com
15.9 Pre-Shared Key
A pre-shared key identifies a communicating party during a phase 1 IKE negotiation (see
Section IKE Phases for more on IKE phases). It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure connection.
163
Type an e-mail address (up to 31 characters) by which to identify the remote IPSec
router.
PRESTIGE B
Local ID type: IP
Local ID content: 1.1.1.2
Peer ID type: E-mail
Peer ID content: tom@yourcompany.com
PRESTIGE B
Local ID type: IP
Local ID content: 1.1.1.10
Peer ID type: IP
Peer ID content: N/A
Chapter 15 VPN Screens